200-155 pdf

Prepare for Cisco 200-155 exam test with best useful Cisco CCNA Data Center 200-155 dumps pdf files and vce youtube demo update free shared. Latest Cisco CCNA Data Center 200-155 dumps exam training materials in PDF format free download from leads4pass. “Introducing Cisco Data Center Technologies” is the name of Cisco CCNA Data Center https://www.leads4pass.com/200-155.html exam dumps which covers all the knowledge points of the real Cisco exam. Newest helpful Cisco CCNA Data Center 200-155 dumps exam questions and answers update free try, pass Cisco 200-155 exam test easily at the first time.

Best Cisco 200-155 dumps pdf files free download: https://drive.google.com/open?id=0B_7qiYkH83VROUdnZWRYLTJta1E

Best Cisco 200-150 dumps pdf files free download: https://drive.google.com/open?id=0B_7qiYkH83VRNFFRMURQbmZ4T1U
200-155 dumps
QUESTION 1
Which statement about slow inter VLAN forwarding is true?
A. The VLAN is experiencing slowness in the point-to-point collisionless connection.
B. The VLANs are experiencing slowness because multiple devices are connected to the same hub.
C. The local VLAN is working normally, but traffic to the alternate VLAN is forwarded slower than expected.
D. The entire VLAN is experiencing slowness.
E. The VLANs are experiencing slowness due to a duplex mismatch.
Correct Answer: E

QUESTION 2
What is the advantage of using a multipoint interface instead of point-to-point subinterfaces when configuring a Frame Relay hub in a hub-and-spoke topology?
A. It avoids split-horizon issues with distance vector routing protocols.
B. IP addresses can be conserved if VLSM is not being used for subnetting.
C. A multipoint interface offers greater security compared to point-to-point subinterface configurations.
D. The multiple IP network addresses required for a multipoint interface provide greater addressing flexibility over pointto-point configurations.
Correct Answer: B

QUESTION 3
What are three values that must be the same within a sequence of packets for Netflow to consider them a network flow? (Choose three.)
A. source IP address
B. source MAC address
C. egress interface
D. ingress interface
E. destination IP address
F. IP next-hop
Correct Answer: ADE

QUESTION 4
What occurs on a Frame Relay network when the CIR is exceeded?
A. All TCP traffic is marked discard eligible.
B. All UDP traffic is marked discard eligible and a BECN is sent.
C. All TCP traffic is marked discard eligible and a BECN is sent.
D. All traffic exceeding the CIR is marked discard eligible.
Correct Answer: D

QUESTION 5
Which command is used to enable CHAP authentication, 200-155 dumps with PAP as the fallback method, on a serial interface?
A. Router(config-if)# ppp authentication chap fallback ppp
B. Router(config-if)# ppp authentication chap pap
C. Router(config-if)# authentication ppp chap fallback ppp
D. Router(config-if)# authentication ppp chap pap
Correct Answer: B

QUESTION 6
Which port state is introduced by Rapid-PVST?
A. learning
B. listening
C. discarding
D. forwarding
Correct Answer: C

QUESTION 7
The output of the show frame-relay pvc command shows andquot;PVC STATUS = INACTIVEandquot;. What does this mean?
A. The PVC is configured correctly and is operating normally, but no data packets have been detected for more than five minutes.
B. The PVC is configured correctly, is operating normally, and is no longer actively seeking the address of the remote router.
C. The PVC is configured correctly, is operating normally, and is waiting for interesting traffic to trigger a call to the remote router.
D. The PVC is configured correctly on the local switch, but there is a problem on the remote end of the PVC.
E. The PVC is not configured on the local switch.
Correct Answer: D

QUESTION 8
Which EIGRP for IPv6 command can you enter to view the link-local addresses of the neighbors of a device?
A. show ipv6 eigrp 20 interfaces
B. show ipv6 route eigrp
C. show ipv6 eigrp neighbors
D. show ip eigrp traffic
Correct Answer: C

QUESTION 9
Which two switch states are valid for 802.1w? (Choose two.)
A. listening
B. backup
C. disabled
D. learning
E. discarding
Correct Answer: DE

QUESTION 10
Which parameter would you tune to affect the selection of a static route as a backup, when a dynamic protocol is also being used?
A. hop count
B. administrative distance
C. link bandwidth
D. link delay
E. link cost
Correct Answer: B

QUESTION 11
A router has two Fast Ethernet interfaces and needs to connect to four VLANs in the local network. How can you accomplish this task, 200-155 dumps using the fewest physical interfaces and without decreasing network performance?
A. Use a hub to connect the four VLANS with a Fast Ethernet interface on the router.
B. Add a second router to handle the VLAN traffic.
C. Add two more Fast Ethernet interfaces.
D. Implement a router-on-a-stick configuration.
Correct Answer: D

QUESTION 12
Which statement about MPLS is true?
A. It operates in Layer 1.
B. It operates between Layer 2 and Layer 3.
C. It operates in Layer 3.
D. it operates in Layer 2.
Correct Answer: B

QUESTION 13
Which of the following correctly describe steps in the OSI data encapsulation process? (Choose two.)
A. The transport layer divides a data stream into segments and may add reliability and flow control information.
B. The data link layer adds physical source and destination addresses and an FCS to the segment.
C. Packets are created when the network layer encapsulates a frame with source and destination host addresses and protocol-related control information.
D. Packets are created when the network layer adds Layer 3 addresses and control information to a segment.
E. The presentation layer translates bits into voltages for transmission across the physical link.
Correct Answer: AC

QUESTION 14
The command show frame-relay map gives the following output:
Serial 0 (up): ip 192.168.151.4 dlci 122, dynamic, broadcast, status defined, active
Which statements represent what is shown?(Choose three.)
A. 192.168.151.4 represents the IP address of the remote router
B. 192.168.151.4 represents the IP address of the local serial interface
C. DLCI 122 represents the interface of the remote serial interface
D. DLCI 122 represents the local number used to connect to the remote address
E. broadcast indicates that a dynamic routing protocol such as RIP v1 can send packets across this PVC
F. active indicates that the ARP process is working
Correct Answer: ADE

QUESTION 15
Which Cisco platform can verify ACLs?
A. Cisco Prime Infrastructure
B. Cisco Wireless LAN Controller
C. Cisco APIC-EM
D. Cisco IOS-XE
Correct Answer: B

QUESTION 16
In an Ethernet network, under what two scenarios can devices transmit? (Choose two.)
A. when they receive a special token
B. when there is a carrier
C. when they detect no other devices are sending
D. when the medium is idle
E. when the server grants access
Correct Answer: CD

QUESTION 17
Which option describes what a switch does after it items that a host has connected to a switch port? 200-155 dumps
A. Flood the frame only on all of its trunk ports.
B. Create a MAC to port mapping entry in MAC table.
C. Flood the frame only on all of its access ports.
D. Discard the frame.
Correct Answer: C

QUESTION 18
A network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port?
A. This is a 10 Mb/s switch port.
B. This is a 100 Mb/s switch port.
C. This is an Ethernet port operating at half duplex.
D. This is an Ethernet port operating at full duplex.
E. This is a port on a network interface card in a PC.
Correct Answer: C

QUESTION 19
An engineer is configuring a new MDS switch. The switch is powered on, the customer connects to the console, and the initial setup script is started.
Which two items can be configured during this setup process?
A. default port-channel mode
B. default port VSAN membership
C. default switch port interface state
D. default zone mode
E. default storage VDC
Correct Answer: CD

QUESTION 20
What are two drawbacks of implementing a link-state routing protocol? (Choose two.)
A. the sequencing and acknowledgment of link-state packets
B. the requirement for a hierarchical IP addressing scheme for optimal functionality
C. the high volume of link-state advertisements in a converged network
D. the high demand on router resources to run the link-state routing algorithm
E. the large size of the topology table listing all advertised routes in the converged network
Correct Answer: BD

High quality Cisco CCNA Data Center 200-155 dumps pdf practice materials and study guides free download from leads4pass. The best and most updated latest Cisco CCNA Data Center https://www.leads4pass.com/200-155.html dumps pdf training resources which are the best for clearing 200-155 exam test, and to get certified by Cisco CCNA Data Center. 100% success and guarantee to pass.

Latest Cisco CCNA Data Center 200-155 dumps vce youtube: https://youtu.be/MHDYkPVUMBQ